STENHØJ STENOMAT Condensate Drain

STENHØJ condensate drain

Especially in small installations is definitely a need for drains working without air loss. Everywhere: from compressor, air receivers, filters, dryers. Float or time-controlled drains may stick, are sensitive to particles and cause malfunctions.. Or they open too early and too long thus causing high losses of your most expensive and most valuable energy: compressed air. The STENOMAT drains condensate automatically, reliable and economically, without losses of compressed air.

Whilst collecting the condensate the diaphragm is closed by the system pressure. As soon as the sensor detects liquid - either oil or water - the magnet pulls up the anchor plate. The chamber above the diaphragm deflates, the condensate is driven out by the systempressure. As soon as the magnet releases, the drain closes.

STENOMAT, This means compact dimensions, well estimated details for compressor stations up to 100 m³/min.

Sensors without moving parts. Safe function without sticking or blocking means safe working without air loss.

Condensate entrey from the top. Installation without additional dittings under filter housings or air receivers.

Condensate entry from the rear side. Means installation in narrow spaces on ground level.

Cable at the rear-side and slopped display. Easy reading from every position. Sophisticated electronic control. A Continuously selfmonitoring electronic, a potential free malfunction contact and automatic routines ensure long term reliable function.

STENHØJ STENOSEP oil/water separator

STENOSEP - oil/water separators

Separators for the purification of compressed air condensate
Whilst using a drain, oil condensate is separated. So far, so good. But anyone who tries to skimp on the next stage will pay for it, because condensate consist of approximately 97% water - but only 3% contaiminant. So anyone who employs a specialist company for the disposal is throwing away money straight out of the window. What could be more logical than to use a reliable, in-house processing system. Its name: STENOSEP.

A pressure relief chamber separates condensate and expanding air. The condensate then passes a sedimentation compartment - easy to remove thus easy to clean. The next step is the coalescing foam with its additional oil separation effect.

Free floating oil is siphoned off into an oil can. The water is purified in the activated carbon adsorber from the last oil droplets. Pure water leaves the unit ready to be drained.

The range of STENOSEP: 7 sizes - the smallest up to 120 m³/h - the biggest up to 7.200 m³/h to allow perfect match to your compressor room. Best match, best economy for your benefit.